![]() ![]() ![]() Verify that you have the custom kernel.To find out the version of your kernel, run uname -r: uname -r If you see anything at all after the dash, you are running a distribution kernel. Via SSH, log in to your server as 'root.' See Switching to the Root User on Your Linux Server for information. Unless you downloaded, compiled and installed your own version of kernel from, you are running a distribution kernel.If you decide to attempt this procedure, we recommend backing up your server and reprovisioning it if you cannot complete the steps. However, if you do not want to reprovision your server, you can update your kernel manually and install a RAID card driver from ElRepo.Ĭompleting these steps requires in-depth Linux knowledge and is an advanced procedure. Announcing the latest release of CentOS Linux 8 (2111) We are pleased to announce the general availability of the latest version of CentOS Linux 8. Before upgrading your kernel, you can use the command uname -ir to get the version of the kernel that your Droplet is currently using and your systems. Updating the latest kernel version on Centos 7 is explained in this manual. For more information, see Starting over with My Server (Reprovision). Linux kernel is one of the largest open source project with upgrading versions. Thus, if the latest minor version of CentOS-6 is version 6. This installs an updated kernel that has drivers for your RAID card as well as all necessary security updates. The CentOS Project provides updates or other changes ONLY for the latest version of each major branch. If the installation was successful, the output should show the Linux Kernel 6.3 version. ![]() This command will display the kernel version of your CentOS Stream 9 or CentOS Stream 8 system. To remedy this, we recommend reprovisioning your server. To check the currently running Linux Kernel version on your system, enter the following command in the terminal: uname -r. ![]() However, updating to the current kernel could remove access to your hard drive. To provide the necessary drivers for your RAID card, we used to install a custom kernel on your server. If your CentOS 5 server was provisioned prior to Dec 17 2010, then you are likely not running the latest CentOS kernel and are missing many important security patches. ![]()
0 Comments
Leave a Reply. |